Welcome To The PSI Blog

Frankenstang Project: Custom exhaust

by Kyle Tomita on Thu, Mar 24th, 2011 | Client Vehicles, Fabrication

Like many parts of this project, the exhaust needed to be a custom fabricated unit because of the space limitations.  Under the car is TCI's rear torque arm suspension.  This suspension prevents binding under corner and allows for a lower ride.  However, this new setup poses an issue for the exhaust system. 

Above is a shot of the underside of the car. 

Alex Laventure needed to fabricate the exhaust system so that it weaves around the suspension setup and other components. 

The exhaust bolts up to the custom made headers Alex fabricated previously. 

The exhaust runs toward the rear and goes up and over the rear torque suspension setup.

The exhaust ends with a Magnaflow muffler. 

The Frankenstang project is progressing well.  The transmission was also installed.  The car should be ready to start up soon.  Check back for updates.