Welcome To The PSI Blog

RX-7 leaves a little wider

by Kyle Tomita on Fri, Dec 17th, 2010 | Client Vehicles, Fabrication

The RX-7 that had overfenders attached by Alex Laventure is ready to leave to go to the bodyshop.  For the build process of the overfender installation check out this blog, http://tunedbypsi.com/blog-entry.php?How-wide-can-you-go-160.

The client wanted to fit 18 x 10″ in the front and 18 x12.5″ in the rear.  These Meisters are wrapped with Toyo Proxes R888, with 2285/30 R18 in the front and 335/30 R18 in the rear.  We accomplished it by installing overfenders in the rear and modifying the front end.  An aftermarket bumper was used.  Under the hood, some components needed to be relocated from the inner fenders, which were removed.

Here are some shots before the car was picked up by the client and taken to the bodyshop for prep and paint.

blog rx7 leaving

RX-7 with wide wheels at PSI